What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
07.06.2025 06:46

nine
These are simplified answers to the original question, and does not change anything I wrote above.
This is 'the assistant's answer'
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
A fuse is a non-resetable over current circuit protector.
Why does my vagina and around my butthole itch? I don't have weird discharge and I'm still a virgin.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
eight
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
What does a fuse do?
Witness testifies that Diddy dangled her over a balcony - BBC
so, what happens?
There are three different concepts here that are getting confused.
the problem then depends on "how fast does the fuse operate?".
[image of Common-mode choke]
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
The other is “what does a “fuse” do?”
My boyfriend won’t tell me his past and it hurts me so I broke up with him what do I do?
Barnstars:
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
The MOV will conduct when the voltage exceeds 50% of line voltage.
What does a passable feminine crossdresser look like?
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
but this device (an Inductor) … impedes the rapid changes in the current.
The Law Firms That Appeased Trump—and Angered Their Clients - WSJ
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
He then asserts :
At least they know the answer if they wanted it.
Why did lobsters evolve bright colors if they are neither poisonous nor venomous?
[old diagram got deleted by accident]
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
One
Ray Dalio: ‘We should be afraid of the bond market’ - CNN
This device then solves the entire problem.
2024–10–16 [ OO OLAOYE OYEBODE ]
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
but I think this circuit , shows a few more pieces.
Here is a simplified AC power diagram.
This is where this question deviates from being a 'generic' question, and becomes more specific.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Upvotes:
At one ohm, the resistor has a maximum of 1 watt power.
These devices are installed between the “hot” and “neutral” and protective ground.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
What is lightning?
So, the voltage could go up to 500 volts, and the fuse will not open up.
This is where the MOV conducts again, and dissipated the energy.
(Dc diagram shown, AC is similar).
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Edit 2024–10.
The third is lightning and “how it gets conducted into a home.”
An AC voltage/ current source, and an ac inductive load.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
The bolt then partially travels down the line to your home.
He then describes Rainy Season and Lightning.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
It also is a device that limits the change in current flow.
It seems Mohan does not understand the difference between a comment and an Answer.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
a photo is worth a thousand words.
Because the load is inductive, the current lags the voltage.(by a bit).
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
In schematic diagrams this is the symbol for a fuse:
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Now when you have a certain ac resistance, then a current flows in a loop.
This one hit behind the barn.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
A circuit breaker is similar, but is resettable.
But it can get overloaded, and no longer works.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–14 [Omar Gharbi Omar Gharbi ]
He then describes the function of a fuse.
But… the neutral is now “floating” because of the 1 ohm resistance.
I post the exact comment here.
There are two important concepts here.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
what exactly is a ‘surge’ protector?
2024–10–10[John johnson John Johnson ]
For this case there are devices called Metal oxide varistors (MOV).
First Sentence:
One is “what exactly is in a ‘surge protector’ ? ”